No GPSR compliance data available for this product.
Glock front sight polymer incl. mounting screw
Glock front sight polymer incl. mounting screw - 4,1 mm
Pickup available at Dynamic Shooting Austria
Usually ready in 24 hours
Original Glock polymer front sight in 2 heights
The original Glock front sight made of polymer with a white contrast dot is the factory front sight on current Glock pistols and is supplied with the retaining screw. The front sight is screwed into the slide from below.
The polymer version matches the factory setup and is the most affordable way to adjust the sights to your point of impact or replace a damaged part.
Available in heights of 4.1 mm and 4.9 mm. A taller front sight shifts the point of impact down, while a shorter one shifts it up. Current models in caliber 9 mm usually come from the factory with a 4.1 mm front sight and a 6.1 mm rear sight; models in 10 mm Auto and .45 ACP have a 6.5 mm rear sight. In practice, shots with the 6.1 mm rear sight often land slightly too low. The 4.1 mm front sight combined with a 6.5 mm rear sight then raises the point of impact slightly, so any remaining deviation is more likely to be just above rather than below the point of aim.
For installation, the front sight installation tool is recommended. The matching counterpart is the Glock GMS rear sight polymer.
Fits:
- All Glock pistols Gen 3, Gen 4, Gen 5, and Gen 6, including MOS, Crossover, and Slimline models
what's included:
- 1x front sight
- 1x retaining screw
Number according to exploded diagram: 16
OEM part number:
- 4.1 mm: 7073
- 4.9 mm: 33366


